Printing Information The innner part needs support. Other can be print without it.
To Inject the silicone - Soak all mold parts in a bath of 1/3 water 2/3 dish soap - Assembly the mold wet - Lock the mold with 4x Ø3mm rod (BBQ sick is perfect) - Get High Temperature silicone. (Any brand of Hi-Temp RTV Silicone Gasket) - Inject the Silicone from bottom in the 7 injection holes. Start by the 3 center ones - Check on the lid part that the 4 air vents are pouring silicone out. if not add more silicone from the bottom where it is missing - Let cure at least 12h - Remove the Outer and lid parts and keep the case around the inner part - Let cure another least 12h - Cut off the excess on the case - Remove the inner part - Your good to go ! :)